Metalwork - Exam Papers - OL - Paper - 2006

(a) This is a: Hand File
Flat File
Square File
Round File
(b) Part ‘X’ is called the: Frame
Spindle
Anvil
Sleeve
(c) A die should be used with a(n): Tap Wrench
Box Spanner
Adjustable Wrench
Stock
(d) This is a: Rivet Snap
Pop Riveter
Rivet Set
Bolster
(e) This brass sheet part can be formed using a: Bench Vice
Hand Vice
Toolmaker's Clamp
Folding Bars
(f) This is a: Morse Taper Sleeve
Drill Drift
Reamer
Chuck Guard
(g) This lathe part is known as a(n): Top Slide
Tool Post
Tool Holder
Tailstock
(h) Part ‘X’ is called the: Chuck Key
Chuck
Spindle
Motor
(i) Before drilling, hole centres should be marked with a(n): Pin Punch
Outside Calipers
Centre Punch
Inside Calipers
(j) This instrument is a: Radius Gauge
Wire Gauge
Screw Pitch Gauge
Feeler Gauge
(k) This hammer head is made from: Cast Iron
High Speed Steel
High Carbon Steel
Stainless Steel
(l) This fastener should be adjusted using a(n): Ring Spanner
Vice Grips
Allen Key
Box Spanner