Metalwork - Exam Papers - OL - Paper - 2008

(a) This holding device is a: Hand Vice
Bench Vice
Leg Vice
Machine Vice
(b) This tool is a(n): Ring Spanner
Adjustable Wrench
Box Spanner
Vice Grips
(c) Taps are used to form: Internal Threads
Buttress Threads
External Threads
Acme Threads
(d) The brass used for brazing is called: Spelter
Solder
Enamel
Flux
(e) Part ‘X’ is called the: Point
Face
Edge
Tang
(f) This technique is called: Parallel Turning
Taper Turning
Knurling
Facing
(g) The distance ‘X’ is called the: Crest
Flank
Root
Pitch
(h) A micrometer can measure to an accuracy of: 1 mm
0.5 mm
0.1 mm
0.01 mm
(i) This tool is called a(n): Outside Calipers
Spring Dividers
Odd Leg Calipers
Inside Calipers
(j) The drill point angle is: 118°
90°
180°
60°
(k) This drawing shows a: Counterbored Hole
Contersunk Hole
Pilot Hole
Blind Hole
(l) Tool ‘X’ is a: Scriber
Parallel Punch
Centre Punch
Centre Square