Metalwork - Exam Papers - OL - Paper - 2012

(a) This tool is a: Chisel
Soldering Iron
Centre Punch
Drill Drif
(b) This drill bit is guided by a: Clearance Hole
Countersink Hole
Pilot Hole
Punch Mark
(c) Part ‘X’ on a thread is
called the:		 Flank
Pitch
Crest
Lead
(d) This tool is used when: Filing
Drilling
Threading
Riveting
(e) This file should be cleaned
using a:		 Dividers
Double Cut
File Card
Centre Punch
(f) This bench tool is a: Cross Pein Hammer
Ball Pein Hammer
Claw Hammer
Mallet
(g) Part ‘X’ is called the: Ruler
Centre Square
Bevel
Protractor
(h) The point angle of a standard
twist drill is:		 30°
60°
118°
210°
(i) This fastener is a: Spring Washer
Split Pin
Grub Screw
Set Screw
(j) This technique is called: Parallel Turning
Knurling
Taper Turning
Facing
(k) The depth of a hole is
measured using a:		 Micrometer
Drill Gauge
Depth Gauge
Surface Gauge
(l) This tool is a(n): Open Spanner
Tap Wrench
Adjustable Spanner
Box Spanner