Metalwork - Exam Papers - Practical - 2013
Instructions to candidates
- Each candidate is required to prepare materials and make Part 4 and Part 5, according to the materials
list and drawings shown, prior to the Practical Examination in May 2013.
- Prepared materials and finished components must be the candidate’s own individual work and
should be clearly identified and safely stored until examination day.
- If you use machinery other than that specified in the equipment list, (below), to process any part of the examination material, you will lose marks under the relevant headings in the marking scheme.
||110 x 85 x 5
||40 x 40 x 4
||100 x 60 x 4
||44 x 20 x 4
||Material and Description
||M6 x 16 Pan Head Set Screw
||M5 x 16 CSK Set Screw
||M6 Nylon Locknut
||M5 Hex Nut
Usual marking-out and measuring tools.
Usual bench fitting tools and equipment.
Scribing block and surface plate (one per five candidates).
M5 taps (to suit machine screws) and suitable tapping wrench.
Set of drills: Ø3.5, Ø4.2, Ø5.5, Ø6 and Ø10.5mm, with spares.
Set of usual files, to include:
250 mm hand rough
250 mm hand smooth
150 mm warding rough
250 mm half-round rough
250 mm half-round smooth
Set of needle files (one set per five candidates).
Junior and standard hacksaws with spare blades.
One pair of aluminium or fibre protective vice clamps per candidate.
Screwdriver to suit machine screws supplied.
Spanners to suit the nuts supplied.
Half sheet of fine grade emery cloth per candidate.
Half sheet of medium grade emery cloth per candidate.
Number punches, or engraving equipment.
Light clear rust preventive aerosol spray.
Protective goggles at all machines.
Note: If candidates use machinery other than that specified in the list above to process any part of the
examination material, they will lose marks under the relevant headings in the marking scheme.
Download Solidworks Parts, Solidworks Drawings and PDFs of Drawings, for Practical.